Warranties

Ikon Commercial Limited (Ikon), as a New Zealand importer, hereby warrants (subject to the exclusions and conditions set out below) to the consumer (The Consumer) of the brands of sinkware supplied directly or indirectly by or from Ikon that the product (The Product) shall be free from manufacturing defects in materials or workmanship for the period of time specified on each product catagory from the date of original purchase of the product from Ikon or from the retailer (as the case may be).

Subject to the below mentioned exclusion and conditions, the obligations of Ikon under this warranty shall be limited to either of the following (at Ikon’s sole option):
1. To without charge repair or replace the defective Product(or the defective parts there of) and to reinstall the repaired or replaced product ( or to pay reasonable costs of installation):
or
2. To refund the Consumer the original purchase price for the defective products:

AND such repair, replacement or refund shall constitute fulfilment of all of Ikon’s obligations under this warranty. To the extent permitted by law Ikon will not whether by virtue of this warranty or otherwise be liable for and hereby disclaim any liability for any incidental, economic or consequential loss, expenditure or damage, directly or indirectly suffered by the Consumer or any other person in respect to any defect in the Product.

This warranty does not apply if:

1. The Product has been installed, used or cared for in any improper manner or otherwise contrary to any specifications, instructions or recommendations contained in any brochure or materials supplied on the original purchase of the product. Ikon will not be liable for replacement of a benchtop when products have been undermounted into laminate, as this goes against Ikon’s recommendations.

2. Any attempt is made to repair or modify the product in any way by any person without written authority of Ikon.

3. Installation of the Product has occurred without regard to the installation instruction provided and full consideration is given to all regulatory codes covering electrical, gas and plumbing installations.

4. A product is installed in a manner that obstructs access for inspection or maintenance, requiring intervention from a third-party service provider to facilitate access, any associated costs for this service will not be covered by Ikon. The responsibility for ensuring adequate installation and accessibility of the product rests with the installer. Ikon shall not be held liable for expenses resulting from installation practices that hinder access to the product.

5. That this warranty does not extend to:
a) light globes and filters of any ages on rangehoods;
b) transportation or travelling costs involved in the repair when the product is installed outside in rural areas.
c) damage to the ceramic glass caused by liquid or solid spillover, lack of maintenance or impact;
d) damage to surface coatings caused by cleaning or maintenance using products not recommended by the owners handbook;
e) defects caused by normal wear and tear, accident, negligence, alteration or misuse, and “act of God”
f) The Product is not in the possession of the original Consumer;
g) The Product has been dismantled, repaired or serviced by other than an authorised Ikon service person.

6. All stainless steel sinks must be bonded to the general mass of earth. In situations where it is not required for electrical compliance it must be done for the purpose of equipotential bonding.

7. A claim under this warranty is not notified in writing to Ikon within a reasonable period after the defect in the Product would have become apparent to a reasonable person.
If a service call is required and it is not a result of either faulty materials or workmanship, then Ikon or the service agent will charge the customer directly for the service call out. All warranties must go through the approved warranty process. No warranty claims may be expressed or implied by any party other than the warranty claims.
Any claim under this warranty must be made in writing to Ikon (info@ikon.nz) and must be supported by reasonable evidence of the date of original purchase of the Product and suspected defects in the Product must be made available for inspection by Ikon or it’s authorised representatives.
Nothing in this Product warranty shall override or negate any statutory right or remedy that may be available to the Consumer under the Consumer Guarantees Act 1993, except where the Consumer has acquired Product for the purposes of business or commercial use.
Official decisions will always be made in writing once a claim is fully investigated. Please refer to our website for latest updates and warranty conditions.

8. All Ikon products dispatch will have manuals and installation instructions installed, please make sure these are read and retained. If these are missing from your product please contact your supplier/installer or download these from our website.

Disclaimer
Ikon Commercial Limited, is constantly seeking ways to improve the specifications, design and production of the Product. Alterations take place continually. Whilst every effort is made to produce up to date literature, brochures should not be regarded as an infallible guide to the current specifications, nor does it constitute an offer for the sale of any particular Product.
Product cutouts indicated in our literature are indicative only. Actual examples of the Product only should only be used to define cutout sizes. Distributors, agents and retailers have no authority to bind Ikon by any express or implied undertaking or representation.